large_290be7df36834e80f38ab311ee00e601
large_bcd83d8a02c7ea78d0435cb9b7fae33elarge_86262fc24491237d282ad301e048846elarge_a431b2b3470be4f5900c2b9cc1f5fea9

Slider Door Stop

£10.83

Does your slider make a loud THUNK when it closes? You probably need this formerly-NLA (no longer available) slider door stop.

Only 1 left in stock

SKU: GVW-251-843-876. Categories: , , .

Product Description

Does your slider make a loud THUNK when it closes? You probably need this formerly-NLA (no longer available) slider door stop.

3D printed from flexible (yet tough) material, this slider door stop has a taller spine to make installation easier. You don’t have to remove the door or the slider track cover (see Installation Notes tab for tips and tricks).

GoWesty-designed in the USA.

 

It is possible (although fiddly) to install this stop without removing the slider door or slider track cover. It is one of those jobs that rewards small hands and patience, but it is possible, trust us.

We recommend removing the front screw holding the slider track cover so the bottom edge can be pulled outward to make a bit more room. The trick is to open the slider door a couple of inches and then fish the stop up in there holding it between the tips of your index and ring fingers and get it set in place in the slot. This will take some trial and error so don’t get discouraged. Try and apply enough pressure to get it to stay in place in the slot — using a long screw driver to place some pressure on it while you hold it in position can help. Now, open the slider door fully, go around to the front edge, grab the spine sticking through the slot with a pair of pliers and pull it in to place — you will need to work back and forth along the spine to get it seated along the whole width.

 

 

 

Reviews

There are no reviews yet.

Be the first to review “Slider Door Stop”